• Properties

    Property
    Max. flow 1540 GPM
    Max suction lift 229.6 feet
    Max. Inlet pressure 580 PSI
    Viscosity 1000 cPs
    Max. temperature 284 °F
    Impeller type Closed 
    Max. free passage 0.67 inch
    Max. drive power 60.35 hp
    Speed 3000 / 3600 rpm 
    Available frequency 50 / 60 Hz 
    Materials wetted parts Stainless steel 316L or similar
    Mechanical seal configuration Single balanced, quench, double
    Available O-ring materials EPDM, FKM, FEP-FKM, FFKM, Silicone
    Connections Flanges according to EN1092-1/11 PN40. Tri-Clamp fittings. etc. 
    Surface finish Industrial, internal welds not hand polished, electropolished
    Certificates 1935/2004 EC. FDA. EAC 
  • Description

    The Packo stainless steel pumps of the IPP3 series are pumps made of solid, machined stainless steel 316L and are extremely suitable for high system pressure applications up to 40 bar.

The IPP3 pump series

  1. Fully machined stainless steel, solid design
  2. Large seal cavity to clean mechanical seal properly
  3. Monobloc execution with std. IEC motor

 

Application areas

The Packo high pressure pumps of the IPP3 series are used primarily in the reverse osmosis (RO) applications for the filtration of, for example, contaminated CIP-water, whey, etc. They are also used as a booster pump in a variety of skids.

You will find them in just about all industries including the dairy industry, breweries, beverage industry as well as in water treatment industry.

Your benefits

  • Suitable for system pressure applications up to 40 bar
  • High pump efficiency resulting in lower energy consumption
  • Low NPSH values: less risk on cavitation
  • Electropolished: higher resistance against corrosion
  • Easy and robust construction and easy maintenance: less downtime
  • Standard components
  • Easy to install
  • 1 mechanical seal diameter for the entire range

Performance Curves

At 2900 RPM